Pumice is of volcanic origin and has been around for hundreds of years and used for a variety of purposes. Before modern technology developed the fine sandpapers that are common in the marketplace today, pumice along with many other materials were used as abrasives. The wood finisher used a felt block and often a leather-covered block with pumice powder to sand the wood smooth. Pumice was also used to polish shellac and resins to fine high-gloss finishes. The pumice for the wood finisher was ground and filtered into many different grades and sizes much the same way as we buy different grades of sandpaper today. No doubt, at some time during sanding, it was discovered that the pumice not only acted as an abrasive but filled the wood grain at the same time. The pumice method of grain filling has been with us for hundreds of years and is still the preferred method of grain filling for many wood finishers.

Lets start our grain filling now . . .

After letting the instrument “gas out” for a few hours we will be ready to fill the pores and grain. This is the pumicing operation. At this point we should mention that there are some species of wood that do not require grain and pore filling. The top of the guitar will not have to be grain filled. Spruce, Cedar, and Maple are examples of "closed-pore" woods which do not have to be grain filled, and with some experience you will recognize woods which require grain filling and those that do not.